Most of us depend on the sun to heat the pools in the summer. There are some hot days when it would be nice to cool off in the pool without putting on a thick layer of sunscreen. For those days that exceed 90 degrees, why not use some of your existing patio furniture to create some pool shade? Putting an umbrella in the center of an above-ground pool is a simple way to take a break from the sun’s harmful rays while enjoying the water.
How to make a pool shade?
Loosen the holds of the umbrella to its weighted base. Then, remove the umbrella from the base and a center table hole. Place both the umbrella and its base next to your pool entry point. If possible, have someone available to deliver these to you after entering the pool.
Use a folded towel under the umbrella base. The towel will protect the pool liner from being damaged by the base. Dip the umbrella base in the center of the pool. Check that the towel is still below the base.
Insert the lower end of the umbrella into the submerged base. Hand-tighten the fixing element that holds the umbrella in the base. In case the fixing element is out of reach, you may have to perform this step underwater.
Open the umbrella completely and snap it into position. Foam pipe insulation installation used to insulate hot-water pipes under houses around the axis of the umbrella exposed to keep swimmers safe from colliding with the pole while swimming. Foam pool noodles/sticks can be used as well.
Consider installing a sail curtain, if you want to create a more permanent shade for your pool. Candle curtains are triangle-shaped covers that come in a variety of styles and can offer a greater area of shade.
While an umbrella might not be an ideal structure in a pool with a lot of active children, it is an effective way for a mother to cool off with her baby, without risking a burn on the baby’s sensitive skin. Do not leave the umbrella in the pool for extended periods. Pool chemicals can destroy the umbrella. Monitor children closely when using a pool umbrella. Never dive or jump near the umbrella.
Set up shade above ground pool
The addition of a pool on the floor of your backyard can immediately create a paradise where you can go to relax and cool off in the summer. If your garden does not have many trees, your paradise can quickly become a pain due to excessive sun exposure. The best way to avoid this issue is to install a pool shade from the pool curtain to keep the sun’s rays from the temperature and bearable.
Decide where you want to install the curtain candle for maximum sun protection. Mark the perimeter of the area by inserting four small marking flags where the steel posts are then installed, two on each side of the pool.
Measure the distance between the length and width of the marking flags. This will be the size of the candle that you will have to buy. Check to see if the candle curtain kit comes with steel posts, or if it must be purchased separately.
Dig a hole 4 feet deep at each point you have marked with a flag. Add premixed cement to a bucket and add water according to the instructions.
Each steel post is stabilized until the cement is dry by tying it with a rope to the side of the pool. Install the brackets and hooks that come with the curtain candle according to the manufacturer’s installation instructions.
Lay the candle curtain on the floor and place a hook in each corner. Hook each corner into the installed steel posts. Adjust the tension of the curtain candle according to the manufacturer’s instructions.
Check with your local service company before installing the steel pole to make sure they do not interfere with underground cables or pipes. Check with your city to ensure that it is not necessary to obtain any building permit before installing the curtain sail.
Another great idea for creating pool shade is the creation of a shade tent that you don’t have to install. A candle curtain kit can be purchased online or at a local department store. If the game does not contain steel posts, they can be purchased at a local wood or hardware store. Marking flags can be obtained from the local electricity or cable company and in most department stores.
Heat a pool in the shade
The most effective way, but that more work requires is to make our home solar heater. We will only need a tube section of a few meters (the longer, the better the water will heat) rolled up on board.
The tube will be connected to the treatment plant and will divert a certain amount of water towards the spiral. It is being oriented towards the sun’s rays. That will heat the water naturally. This method raises the water temperature by about 5ºC in a single day.
Homemade thermal blanket
The last method to heat the water, but no less effective. It is to make a homemade thermal blanket, although, as in the previous cases, you can always gain it.
It can be done with various types of materials. One of them is bubble wrap, effective. The problem with this plastic is that it eventually breaks down, so it is only useful for a season.
If this method is the one you like the most, they sell more resistant plastics that are sure to endure several seasons. This method increases the water temperature to 5º. It also considerably reduces the evaporation of water and also the use of chemical products passes its cleaning.
0
0
Average Rating