A fire alarm service visit is more than just pressing a test button. It is a very detailed inspection of all the components of the fire alarm system to check that everything is working correctly.
Detector Testing
We check that each smoke, heat or multi-sensor detector is activated within the expected time. It will then send a signal to the fire alarm panel. If a detector is slow to activate or is blocked by dirt etc then it will need to be cleaned or even replaced.
Call Point Inspection
Each of the manual call points are tested with the relevant test key. If the key is pressed the correct signal is sent to the panel. Any physical damage to the call point or any obstruction to the bezel are also checked and recorded.
Panel and Zone Review
Control Panel Testing – Review of Fault Logs, Error Codes & Zone Configuration. Many previous problems are highlighted up within this section of testing. Also, possible causes of wiring faults before they actually fail.
Battery and Power Supply Checks
Checking the batteries for the required power reserve for back-up in the case of a loss of mains supply and replacing as required with suitable new backup batteries of the correct ampere hour rating and type for the particular fire system.
Logbook and Documentation
Under BS 5839 requirements for servicing a fire alarm logbook must be completed with details of findings and actions completed, and the name and company of the engineer who carried out the work.
A useful reference for Fire alarms Milton Keynes is https://isefireproducts.co.uk/fire-alarm-systems/milton-keynes/.
Knowing what a service visit for your fire alarm entails, you can then ask the right questions as to whether or not the fire alarm servicing has been carried out to the correct standards and if all points have been covered.
0
0
Average Rating