A clock can be both decorative and functional. However, decorative clocks can put a significant dent in your home or office improvement budget. Fortunately, you don’t have to spend a fortune on one because, with a little imagination, you can make virtually anything into a clock, from a ping-pong ball to wood. Check out these five gorgeous DIY clock ideas that can instantly change your home or office space, which could also improve your gaming experience at best Canadian online casino.
Ping-Pong Ball LED Clock
Ping-pong balls serve as diffusers for a set of LED lights that display the time in this DIY clock. When turned off, it appears to be a stack of ping-pong balls in a frame, but when activated, the LED light show offers a beautiful visual impact while displaying the time. It’s also quite simple to make, just like the slots at real money casino Australia.
To begin, collect about 100 ping-pong balls (lower or increase the number to make a clock that is as large or tiny as you wish), cut each one just beneath the midline to form a hexagon, and then glue them together. Finally, arrange them into a frame (of any shape) with the LEDs and Arduino already attached to the backplate to complete the setup.
Linear Clock
A linear clock is often simple, minimalistic, and an excellent addition to any office desk. So, instead of buying one, make one by following this simple DIY technique. It is powered by an Arduino connected to a motor driver and controls the clock hands with a stepper motor.
A foam core board, two curtain rails, pulleys and stepper motors, four sewing bobbins, thick thread, an Arduino, and a 6-9V power source are all required. Follow the instructions in the guide, and then run the code to see your linear clock tick away.
Digital Papercraft Clock
This is yet another simple yet useful DIY clock. It boasts a stunning white 3D design with numbers that move in and out of the pane, casting a shadow that allows you to see them and tell the time.
You’ll need an Arduino Uno, a servo motor controller, around 28 servos to move all of the digit segments, and a DS1307 clock breakout to track time for this project. To make the digits, you’ll also need cardstock, double-sided tape, sticky pads, aluminium tubing, a paper cutter, a glue gun, and a knife.
Once completed, you’ll have a magnificent DIY clock with a one-of-a-kind 3D digit-changing mechanism.
Lunchtime Clock
Hate how time appears to fly by during your office lunch breaks. So, by slowing down during that period, you may slip an extra 12 minutes into your break!
It employs an Arduino with an extra ATmega chip and a few other components to slow time by around 20% at 11 a.m. and then speed up by the same proportion at 11.48 a.m., giving you an extra 12 minutes of guilt-free lunchtime. If your supervisor comes in while you’re still on your break, simply point out the time and they’ll leave you alone.
Lunar Phase Clock
If you’ve always been captivated by celestial bodies, here’s your chance to make one for your office or home. It correctly records different phases of the moon and is an excellent addition to your nightstand, owing to its lamp mode, moon FX modes, date, temperature, and even a wake-light alarm.
You’ll need an Arduino Nano, an OLED display, a super-bright LED strip, a real-time clock, a DHT11 sensor, a buzzer, and three push buttons to create it.
0
0
Average Rating